The GAS Enviro Controller V2 takes care of fan speeds for both AC and EC fans - and not only that, it can also regulate 'on' and 'off' times for practically any piece of equipment in your grow room! Lights (up to 1200w), heaters, humidifiers, and even pumps, can be controlled using data gathered from the environment. This simplifies your set-up, making it easy to control your grow room and maintain a perfect environment from a single point. With the V2, it gives you new features such as minimum and maximum day and night fan speed settings for enhanced control over your environment, the ability to calibrate your temperature and humidity sensorts, automatic dimming function on the LEDs and new green LED lights which won't disturb your plants cycle.
How the Enviro Controller V2 Works
Controlling your fan speed can be critical to the success of your indoor garden. When cold outdoor temperatures hit, it’s handy to be able to reduce air intake flow a little, allowing your grow lights and heaters to compensate. The same can be said for hot summer months, when outside temperatures play havoc with your indoor environment. In this case, turning fans up helps to keep air temperatures optimal. The Enviro Controller V2 controls temperature and humidity levels using its thermostat and humidity sensor (which are now able to be calibrated). The Enviro Controller V2 can regulate either AC fans or EC fans, keeping your grow room parameters in check at all times.
The Enviro Controller V2 has an easy-to-program operating system, from which you can govern every aspect of your grow room’s environment, including lights (up to 2 x 600w), heaters, humidifiers, dehumidifiers, and even pumps – practically anything that needs to be switched ‘on’ and ‘off’ that doesn’t exceed the total 13 amp rating. Just plug your equipment into the two ‘exit’ plug sockets. These sockets are fully programmable, using information gathered by the probes to switch equipment on when it's needed.
Here's a quick rundown of what the exit sockets can do:
Heaters - these can be set to come on when temperatures drop below certain levels. Unlike a typical thermostatic set-up, you can select different temps for daytime and nighttime!
Humidifiers - set your humidifiers to come on whenever moisture levels drop below your chosen levels. Again, this can be set differently for daytime and nighttime.
Dehumidifiers - works in the same way as for humidifiers, but in the opposite fashion, switching equipment on as moisture levels rise above your selected daytime or nighttime settings.
Timer - you can control any growroom equipment (as long as you don't exceed 13-amp) down to the second! So you can switch everything from your grow lights (up to 2 x 600w) to your grow system pumps.
